









QD Pivot Mount-Short for Aimpoint or Hensoldt Magnifier, LT755
link: https://www.larue.com/products/qd-pivot-mount-short-for-aimpoint-or-hensoldt-magnifier-lt755/
SKU: LT755-30S-c
$199.00
QD Pivot Mount-Short for Aimpoint or Hensoldt Magnifier
This magnifier mount will properly align with the following LaRue mounts … LT659NV, LT660, and LT751.
NOTE: The T1/H1 in the LT660/LT751 will be slightly offset vertically to the magnifier, but will operate properly by adjusting the two Allen screws which allow the user to center the red dot of the Aimpoint sight when viewed through the 3XMag.
QD Pivot Mount-Short for Aimpoint or Hensoldt Magnifier, LT755
$199.00
The options you chose might be on backorder.
Sorry, the chosen combinations are out
of
stock.
SKU: LT755-30S
This magnifier mount will properly align with the following LaRue mounts … LT659NV, LT660, and LT751.
NOTE: The T1/H1 in the LT660/LT751 will be slightly offset vertically to the magnifier, but will operate properly by adjusting the two Allen screws which allow the user to center the red dot of the Aimpoint sight when viewed through the 3XMag.
About VFZ™ Mounts:
VFZ™ is a new theory in the concept of clamping accessories to MIL-STD-1913 rails. Instead of using a horizontal cross-bolt, the VFZ™ uses a vertical bolt that draws up a clamping foot against the lower angle of the rail, seating the mount similarly to a fully-closed LaRue lever. Once installed on the firearm, index marks allow the user to remove the mount, then reattach to the same tension, providing unprecedented return to zero for a non-QD-levered mount. The unique vertical alignment of the clamp allows components that are structurally stronger than traditional cross-bolt designs.
Why should I select VFZ™ Mounts instead of a QD Lever Mount?:
If you intend to leave an optic or accessory on a rail for the life of the rifle, the VFZ™ option is for you. The VFZ™ is intended as a longer-term, semi-permanent mounting alternative to our well-known Speed Levers. While both mounts will allow the user to remove the mount from the weapon, reinstall it in the same position, and return to zero, the VFZ™ mount is intended for users that will not need to constantly remove and install their mounts (especially in the field).